0.00: Open the box and take out your new stylish drawer unit

0.02: Fit the handles into the pre-drilled holes

0.05: Cup of Tea!

0.00: Open the box / boxes and take out all the different pieces

0.15:Locate the instructions, layout and check all the pieces. A typical 500mm drawer pack will have 138 pieces (or should have!)

0.27:Before commencing...
Warning: Installation should only be performed by a competent person - incorrect installation could be dangerous. Before you start, make sure you have the correct tools, plenty of space and a clean dry area for the construction of the unit. Read The instructions thoroughly and run through the order of construction.

The tools you will require are:
Cross head screwdriver Drill
3mm drill bit
4.5mm drill bit
PVA wood glue
Bradawl
2 pairs of Pliers
Hammer

Assembly should be done in the order shown in the diagrams, constructing one unit at a time and keeping the parts together to avoid losing them. Lay large panels on the floor using the packaging for protection. Do not over tighten, or under tighten the screws.

0.37:Fit the runners to the side panel as shown, with the runner wheel facing the front edge of the cabinet. Position the runners using the 3 pre-marked positions and secure in place using 3 x screws per runner. Using a bradawl, pilot a fourth fixing position using 1 x screw per runner. Repeat the above using runners on the other side panel.

0.52:Next, on each of the side panels you need to insert the 10 wooden dowels, making sure that you apply a small droplet of glue in each of the locations holes. Tap these in gently with a hammer to ensure each one locates correctly.

You know what... this is going to take ages,

I really can’t be bothered to type out Steps 5, 6, 7, 8, 9, 10, 11 and 12 just for 1 unit!

It would take a professional fitter 2.5 days to build this kitchen - how long would it take you?

So now you see the advantage of a pre-built German kitchen!